Installation of Cycloidal Pin-Wheel Speed Reducers
Mar 06, 2026
1. When installing connecting components-such as couplings, pulleys, or sprockets-onto the output shaft of a cycloidal reducer, direct hammering methods are strictly prohibited; this is because the structural design of the reducer's output shaft cannot withstand axial impact forces. Instead, use the threaded hole at the shaft end to insert a screw and press the connecting component into place.
2. The shaft diameters of both the output and input shafts are designed to conform to the fit tolerances specified in standard GB1568-79.
3. The lifting eye bolts located on the reducer are intended solely for the purpose of lifting the reducer unit itself.
4. When mounting the reducer onto a foundation, it is essential to verify and align the reducer's installation centerline elevation, levelness, and the relevant dimensions of any connected components. The concentricity of the rotating shafts must be aligned such that the deviation does not exceed the permissible limits specified for the coupling being used.
5. During the alignment process, steel or cast iron shims may be used; the stack height of these shims should not exceed three layers. Alternatively, wedge shims may be used for initial alignment; however, once the reducer has been properly aligned, these wedges must be replaced with flat shims.
6. The placement of shims must be arranged to prevent any deformation of the reducer housing. They should be positioned symmetrically on both sides of the foundation bolts, ensuring that the spacing between them is sufficient to allow the grouting mortar to flow freely during the pouring process.
7. The grouting mortar must be poured to ensure a dense fill, free from any air bubbles, voids, or other structural defects.





