Geared Motor Wiring Guide

Apr 02, 2026

220V vs. 380V: The Nuances of Voltage Selection
The 220V/380V wiring methods for geared three-phase asynchronous motors are fundamentally designed to address startup requirements within different voltage environments. 220V wiring is suitable for residential or low-power applications, while 380V is utilized for high-power industrial demands. Much like selecting a mobile phone charger-where 5V is used for low-current devices and 9V for high-current ones-proper voltage matching is essential for safe and efficient operation.

220V Wiring: Requires the use of a starting capacitor; by altering the configuration of the motor windings, the three-phase power is converted to single-phase power for operation.

380V Wiring: Connects directly to a three-phase power supply; no additional capacitors are required, resulting in a more robust power output.

 

Wiring Procedure: Three Steps to Get the Motor Running
Always disconnect the power supply before wiring! This is the golden rule of electrical work. The specific procedure consists of three steps:

Confirm Voltage: Use a multimeter to measure the power supply voltage, then select the corresponding wiring terminals (connect to U1/V1 for 220V; connect to U2/V2/W2 for 380V).

Connect Capacitor: For 220V wiring, connect a starting capacitor in parallel between terminals U1 and V1 (select the capacitor's capacitance based on the motor's power rating, typically ranging from 5 to 20 μF).

Grounding Protection: Reliably connect the motor casing to a ground wire to prevent electrical leakage and electric shock hazards.

 

Safety Precautions: Details That Determine Success or Failure
Wiring involves more than just "connecting wires"; improper handling of details can lead to fires or motor damage.

Wire Gauge Selection: Select the appropriate wire gauge based on the motor's power rating (e.g., use 1.5 mm² copper wire for a 1.5 kW motor, and 2.5 mm² for a 3 kW motor); using a wire gauge that is too thin can cause overheating and burnout.

Insulation Treatment: Wrap the wiring terminals with electrical insulation tape to prevent short circuits-effectively providing "protective clothing" for the wires.

Test Run Inspection: After connecting the power supply, run the motor under a no-load condition first. Observe whether the motor's direction of rotation is correct and check for any abnormal noises; only apply the load once you have confirmed that everything is in order.