How to Solve an Oil Leak in a Planetary Reducer

Nov 13, 2026

Solutions for Planetary Reducer Oil Leaks

Oil leaks in Planetary Gear Rotary Reducers not only pollute the working environment but also lead to insufficient internal lubrication and severe mechanical wear. Solving this problem requires a targeted approach, and a systematic investigation and treatment of the following four aspects is recommended:

1. Replace Aging Seals and Repair Shaft Diameter

Aging oil seals on the output or input shaft are the most common cause of oil leaks. When cracks, hardening, or loss of elasticity are found in the seals, the machine must be stopped and replaced with high-quality original oil-resistant seals. During replacement, carefully inspect the shaft diameter surface for wear grooves; if the shaft diameter is severely worn, simply replacing the oil seal will not solve the problem. It is necessary to use processes such as adding a bushing or spray repair to restore the shaft diameter to its standard size, ensuring a tight fit of the new oil seal.

2. Reseal the Housing Joints

If the oil leak is located at the reducer housing joint, it is usually due to sealant failure or loose bolts. During treatment, thoroughly clean the old sealant and oil stains from the housing joints and wipe them with anhydrous ethanol. After drying, apply a layer of high-quality flat sealant evenly to the mating surfaces. Then, using a torque wrench, tighten the bolts evenly in a diagonal sequence to ensure a tight seal without any gaps.

 

3. Unclog the Breather Valve to Balance Internal Pressure

During operation, the hydraulic motor reduction gearbox generates internal pressure due to increased internal temperature. If the breather valve is clogged with dust or oil, the high internal pressure will force lubricating oil out through weak seals. Therefore, the breather valve must be cleaned or replaced regularly to ensure balanced internal and external pressure. For equipment operating under harsh conditions, an automatic pressure-regulating breather device can be upgraded to eliminate the risk of oil leakage caused by excessive internal pressure.

4. Standardize Assembly Process and Adjust Oil Level

Improper installation and maintenance are also major causes of oil leaks. During assembly, a torque wrench must be used to tighten all bolts strictly according to the specified torque to avoid uneven force causing housing deformation and gaps. In addition, the reducer's oil level must be checked, and the oil level should be strictly controlled at the center line of the oil window. Excessive oil will cause violent oil churning in the gears, increasing internal oil pressure and producing foam, thus exacerbating the risk of oil leakage.

info-600-600
 

If you would like to learn more about Planetary Reducers, please feel free to contact us! We provide professional solutions and look forward to serving you!