Maintenance And Installation Of Geared Motors
Apr 04, 2026
Points to note regarding the installation and maintenance of geared motors include:
1. Before use, please verify that the geared motor shows no signs of external damage or oil leakage.
2. Please verify that the specifications of the purchased geared motor match the design specifications.
3. Please verify the operating voltage of the geared motor. If the voltage is unstable, a voltage regulator should be installed.
4. Please ensure that the mounting base is securely fastened to prevent loosening during power transmission operations.
5. If accessories such as pulleys, sprockets, or couplings are used, they must be installed strictly in accordance with relevant regulations.
6. During geared motor operation, the actual operating current must not exceed the rated current value indicated on the motor's nameplate.
7. Lubricating grease has been pre-filled inside the geared motor housing; no grease replacement is required for 12,000 hours of operation.
8. Please pay attention to surrounding environmental factors such as temperature, humidity, and acidity/alkalinity levels.
9. The suitable operating environment for the geared motor is a temperature range of -10°C to +40°C, relative humidity below 90%, and an indoor altitude of no more than 1,000 meters.
10. Failure to install, maintain, or operate the unit correctly may result in severe damage to the geared motor.
11. When performing maintenance or disassembly, ensure that the external power supply has been completely disconnected from the geared motor.
12. Safety protection devices must be securely installed to ensure absolute operational safety.
13. The motor requires proper grounding; please refer to relevant electrical distribution regulations.
14. Please thoroughly verify that all mounting components and transmission accessories are securely and correctly fastened before starting the geared motor.
15. If the geared motor is used in conjunction with a variable frequency drive (VFD) for low-speed transmission, an independent auxiliary cooling fan must be installed.
16. For single-phase geared motors, residual charge may remain within the capacitor after power is cut off; please discharge the capacitor or ground the terminals before proceeding.






